Intelligent charger Liitokala ND-4 Отзыв

Charger LiitoKala Lii-ND4Designed to charge NI-MH and Ni-CD batteries AA, AAA and krone with a capacity of up to 3000mAh. It is possible to simultaneously apply different modes (charge, discharge, recovery, test) for each AA or AAA battery. You can set the charge current - 300, 500, 700 and 1000mA. The charger displays on the display information about the charge current, voltage, capacity and charge time of each battery. The device has a USB output, with which you can charge various devices while charging the batteries. Technical parameters: Used batteries: Ni-CD, Ni-MH (AA, AAA, krone) Power supply: Input voltage: 100~240V~, 50/60Hz discharge: 500mAUSB output voltage 5.0V ± 0.3V. USB output current 1A. Dimensions: 130 * 75 * 28mmComplete set: - charger, - power supply, - instructionCHARGE (charge) - normal charging. Install the batteries in the charger, select the charge current with the CURRENT button (values ​​​​300, 500.700, 1000mA are allowed). The default charge current is 300mA. When the battery is fully charged, the display will show "END" and the segments on the battery charge icon will remain lit. By pressing the buttons 1-2-3-4 you can view information about voltage, current, charging time and the amount of mAh "downloaded" into the battery for each installed battery. If the batteries overheat, the charging process is suspended and will be resumed when the batteries cool down. If the charged battery remains in the compartment, then the charger switches to the "drip charge" mode, that is, recharging with a small current to maintain the battery in a charged state (self-discharge compensation). DISCHARGE (discharge) - battery discharge mode and subsequent full charge. This mode is designed to eliminate the "memory effect" of batteries. The charge current can be selected at the initial stage of the process, the discharge current is constant and is 500mA. During the discharging process, the display shows the amount of mAh "drained" from the battery, while charging is no different from the CHARGE.REFRESH mode (recovery) - this process restores the optimal working capacity of batteries that have not been used for a long time or were previously charged with low-quality chargers. The recovery mode starts with a complete discharge of the batteries, and then they are fully charged. Such cycles of discharge and charge will be repeated until the increase in battery capacity stops. Depending on the selected current and the condition of the batteries, the recovery process may take a long time, even up to several days. But the result justifies such an investment of time, many batteries are actually restored almost to their maximum capacity. TEST (test) - a mode for determining the real battery capacity. To do this, the batteries are first charged to full ...